Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Install software

Install the latest Logic Controls software:

...

All other Logic Control drivers are here:
http://bematechus.com/support/product-drivers/ 

...

Logic Controls LS6000 Logic eNet I/O Unit - Setup and configuration 

Set up the LS6000 control units to power, monitor, network and bump bar.

            

Set IP address to the LS6000 unit

  • Use a pen or pointed object to press the reset button on the front of the unit
  • On the bump bar device:
    • During reboot, press the down arrow/scroll button on the bump bar.

...

    • Enter the IP address by using the numbers on the bump bar.
    • Move to next octet by pushing the enter button (to the right of the numbers).
    • After entering the IP address, use the right arrow/home button to scroll to the exit tab.
    • Press Enter to save and exit.

 

Configure system on the PC server

After setting up your LS600 units, open the Logic Controls KDS software to configure the system on the PC server in the upper control bar. 

...

  • After completing these settings, Run the program (on the top, left of LS Setting).

 

 

 

 

 

Database

  • To mimic a Logic Controls database, with everything set up in this document to standardize multiple stores/location, copy (and drop in) these highlighted files in the Logic Controls KDS folder: C:\Program Files (x86)\Logic Controls KDS

 

 







ECM Setup

In ECM, add Locations to Areas within the site. and add the external codes to the Locations. 

...