The purpose of this document is to provide the preferred BroadPOS/Pax Store Parameter settings for PAX terminal configuration.
| Parameter Tab | Value |
|---|---|
| Processor tab (e.g., TSYS, FirstData, etc) | If available for the selected processor |
Start Batch Time, | These values should be set close to System Daily Close (EOD) Time set up in ECM. For example, if System Daily Close Time is 4:00AM, set Start Batch Time: 4:00AM End Batch Time: 5:00AM |
| EMV | |
| Enable EMV Feature | Enabled |
| Credit > Pin Bypass | Auto Bypass |
| Debit > Pin Bypass | Auto Bypass |
| Insert Any Time | Disabled |
| Industry | |
| Industry Type | Restaurant |
| Fleet/Commercial Card Support | Disabled |
| Disabled Fleet/Commercial Card Prompts | Yes |
| Allow MOTO | Disabled |
| Store and Forward | Disabled; unless requested - if requested Enabled - set SAF Mode: Offline on Demand |
| Local Duplicate Check (Pax Store setting in Industry) | Disabled PAX terminals use only card number, transaction type, and amount to determine duplicates – they don't use invoice number. |
Semi Integration Only: Gift/Loyalty Check type INPUTACCOUNT | Excluded from Credit Bin |
| EDC | |
| Manual Entry | Enabled |
| Secure Card | Disabled |
| Tip | Enabled |
| Debit | Disabled |
| EBT (if setting) | Disabled |
| Receipt | |
| *add customer info (among other things this can used for troubleshooting with card processors who will look for Merchant info) | Restaurant Name on line 1 Address on line 2 City, ST and Zip on line 3 |
| Tip | |
| Tip Select | Disabled |
| Misc | |
| Local Duplicate Check (BroadPOS setting on Misc tab, it may also be Industry tab depending on processor.) | Disabled PAX terminals use only card number, transaction type, and amount to determine duplicates – they don't use invoice number. |
| Contactless Module | Internal if supporting tap-to-pay; otherwise. Disabled |
| Receipt Settings > Pre-print | Disabled |
| NFC Logo Settings > Pay Logo | Both |
| Communication | |
| DHCP | Disabled ** NOTE ** IP addresses of PAX devices must be known ahead of time so that they can be set up in ECM, which precludes DHCP. Each PAX device must be set up with its own IP address on the network. |
| Communication Type | Ethernet (REQUIRED) |
| Protocol Type | HTTP GET (REQUIRED) |
| Ping URL | www.google.com |
| DNS | If not specified 8.8.8.8 and/or 8.8.4.4 in DNS 1 & 2 |