The purpose of this document is to provide the preferred BroadPOS Parameter settings for PAX terminal configuration.
| Parameter Tab | Value | |
|---|---|---|
| Processor tab (e.g., TSYS, FirstData, etc) | If available for the selected processor | |
| Start Batch Time, End Batch Time | These values should be set close to System Daily Close (EOD) Time set up in ECM. For example, if System Daily Close Time is 4:00AM, set Start Batch Time: 4:01AM End Batch Time: 5:00AM | |
| EMV | ||
| Enable EMV Feature | Enabled | |
| Industry | ||
| Industry Type | Restaurant | |
| Commercial Card Support | Disabled | |
| Disabled Commercial Card Prompts | Yes | |
| Allow MOTO | Disabled | |
| Store and Forward | Disabled; unless requested | |
| EDC | ||
| Manual Entry | Enabled | |
| Secure Card | Disabled | |
| Tip | Enabled | |
| Debit | Disabled | |
| EBT | Disabled | |
| Tip | ||
| Tip Select | Disabled | |
| Misc | ||
| Local Duplicate Check | Disabled PAX terminals use only card number, transaction type, and amount to determine duplicates – they don't use invoice number. | |
| Contactless Module | Internal if supporting tap-to-pay; otherwise. Disabled | |
| Communication | ||
| DHCP | Disabled ** NOTE ** IP addresses of PAX devices must be known ahead of time so that they can be set up in ECM, which precludes DHCP. Each PAX device must be set up with its own IP address on the network. | |
| Communication Type | Ethernet | |
| Protocol Type | HTTP GET |
...