Page Comparison

Step 1:

• • Open the Device Installer folder and run setup_di_x86x64cd_4.4.0.2RC3.
  • Once installed, click on the Device Installer program; you will see the screen as shown below. Any Lantronix devices on the network should appear. If they do not, click Search.

• • Select your device and click

• •  Assign IP. You can assign an IP automatically or assign a static IP.

Once you've assigned an IP to the boxes, log in to their web configuration by inputting their IP addresses in a web browser. Their web configuration pages are also

accessible in

the Device Installer

 by clicking on the devices and clicking on

the Web Configuration

 tab on the right. Each device has its own web configuration page:

EDS4100 (4-Port) - You don't need to change any settings

. Web browser login: admin/PASS

Step 2:

• • Open the Secure Com Port Redirector folder and run setup_cpr_x86x64cd_4.3.0.3 to install the 2nd program. This allows port assignment to the Lantronix boxes. 
  • CPR

• • Manager should now be installed.  
    (IMPORTANT NOTE: Inaccessible

• •  ports will be automatically detected on the left side under the Com Ports section)

• • Click Search For Devices. 
  • Lantronix devices already on the network will appear in the lower area. Double-click the devices to expand them to show how many ports they have available. In the example below,

• • a 2-Port (.200) and

• • the 4-Port (.38) device are expanded.

• • Click Add/Remove

• •  on the top left to display all assignable virtual ports.

• • For a

• •  4-port

• •  device, flag

• •  the next 4

• •  available ports.

• • Click OK

• •  when finished.
    (NOTE: To remove the virtual ports, deselect the virtual ports and click OK. Click Save

• •  at the top)

• • The new ports

• •  are now highlighted in red and display (New)

• •  next to them. 

• • Select the first

• • new Com. Its settings will appear in the right pane.
  • Scroll down and find the Service, Host, and TCP Port section. 

• • Select the empty box underneath Host
    
  • Type the IP address of your device

• • under Host

• •  along with the corresponding TCP port (shown below). 
    (The first TCP port

• •  on these Lantronix boxes will always

• • be 10001; in succession, the next would be 10002, 10003, 10004, etc. This is determined on how many physical ports are on that Lantronix box.)
  • The edited virtual port is now the first physical port of the Lantronix Serial-to-Ethernet Device. In the example, Com 7 is now physical Port 1 (TCP Port 10001).
    
    
  • (IMPORTANT: If you attempt to double-click to add

• • the TCP port

• •  to the 

• • Host the device'

• • s TCP port

• •  list at the bottom will shrink (screenshot below). To show the

• • available TCP Ports, expand the list. To expand the list, click on an inaccessible Com ports or away from the box. 

Click on the next virtual com port you're going to assign. In this example, Com 8. 

• • Repeat the previous steps; scroll down until you get to

• • the Host and

• •  Service section of the Com's settings. 
  • Click underneath Host area
  • Manually add the device's IP Address

• • under Host

• •  then next its

• • second TCP Port, 10002.